Sennheiser EM 500, Instruction Manual

Page: 40 / 64

Adjustment tips and functions
39
The extended menu “ Advanced Menu ”
To get into the extended menu “ Advanced Menu ”:
왘
From the main menu, select “ Advanced ”.
Setting the receiving frequencies and the frequency banks “U1” to “U6
Via the “ Tune ” menu item, you can set a receiving frequency to be stored
in the current channel or you can select a different channel in one of the
frequency banks “ U1 ” to “ U6 ” and assign this channel a receiving
frequency.
Setting a receiving
frequency for the
current channel
왘
Set the desired frequency.
Squelch
Easy Setup
Setup
Frequency Preset
Name
AF Out
Equalizer
Auto Lock
Advanced
Exit
Menu
Tune
Guitar Tuner Setup
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
When you have selected one of the system banks and then select
the “
Tune ” menu item, the receiver automatically switches to
channel 1 of the frequency bank “ U1 ”. In this case, “ U1.1 ” briefly
appears on the display panel.
Upon delivery, the channels of the frequency banks “ U1 ” to “ U6 ”
are not assigned a receiving frequency.
It is vital to observe the notes on frequency selection on page 45.
왘
Turn the jog dial until the “ Tune ” menu item appears.
왘
Press the jog dial.
The frequency selection appears.
왘
Press the jog dial.
Your settings are stored.
You are back to the operating menu.
Call up “Tune” Select the MHz value
and confirm Select the kHz value;
store the setting
Advanced Menu
531.375 MHz
Tune
B.Ch: U1. 1
531 .375 MHz
Tune
B.Ch: U1. 1
534. 208 MHz
Exit
Tune
Guitar Tuner
“Stored”
PEAK
-10
0 40
30
20
10
-20
-40
AF RF
-30
PEAK
-10
0 40
30
20
10
-20
-40
AF RF
-30
PEAK
-10
0 40
30
20
10
-20
-40
AF RF
-30