Sennheiser EM 500, Instruction Manual

Page: 21 / 64

Using the receiver
20
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the display backlighting of the
receiver changes from red to orange.
If you cannot establish a transmission link between transmitter and
receiver:
왘
Make sure that transmitter and receiver are set to the same frequency
bank and to the same channel.
왘
Read the chapter “Synchronizing transmitters with receivers” on
page 45 and, if necessary, the chapter “If a problem occurs ...” on
page 51.
Switching the receiver on/off
To switch the receiver on :
왘
To switch the receiver to standby mode :
It is vital to observe the notes on frequency selection on page 45.
왘
Briefly press the STANDBY button .
The receiver switches on and the “ Receiver Parameters ”
standard display appears.
542.625
SKM500
ew500 G3
B.Ch: 20.30
EQ
+ 12dB
P
MHz
PEAK
-10
0 40
30
20
10
-20
-40
AF RF
-30
P