Senix CSPE6.5-M, Operator'S Manual

Page: 13 / 64

13 WWW.SENIXTOOLS.COM
CUTTING THIN BRANCHES
STARTING AND STOPPING
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
CUTTING THICK BRANCHES
• Thin branches can be cut off with a single cut.
• To prevent the branch from slivering and buckling, cut
the branch off in several pieces.
When cutting larger branches, the following four cuts
are necessary:
• First cut into the branch from below, outside of the
location where you intend to cut off the branch.
• The cut should go one third to halfway through the
branch (1).
• Cut into the branch from the top, making sure it’s
outside from where the branch is to be sawed (2).
• To keep stump and branch from splintering, do a stub
undercut below branch (3).
• Cut off the stump with one clean cut from top to
bottom. If desired, seal the cut with a suitable
compound (4).
• When finished cutting, turn off the Pole Saw and
disconnect its power supply after use.
• Clean, then store the appliance indoors out of
children’s reach.
• Make sure the power cord is located to the rear, away
from the chain and wood, and kept free of branches
during cutting.
• Hold the Pole Saw to the side of your body.
• Keep a firm, steady pressure on the Pole Saw while
working. Do not try to force the Pole Saw through
the wood, let the chain do the work. Use the gripping
teeth to apply minimal leverage pressure.
• Use caution when reaching end of cut. The Pole
Saw’s weight may change unexpectedly as it cuts free
from the wood. Always remove the Pole Saw from a
wood cut while it is running.
Do not operate the Pole Saw with arms fully extended
or attempt to saw areas that are difficult to reach.
To turn ON, hold the pole saw firmly with both hands.
Press and hold the safety switch located on the left-
hand side of the rear handle above the main power
trigger.
Press the trigger to turn it ON. The safety switch can
now be released. To turn OFF, release the ON/OFF
trigger switch.
Do not return this product to the retail store where it
was purchased. Please call our Customer Service
Department for any issues you may have. For Help Call:
1-800-261-3981
WARNING:
Trigger
Safety switch