User Manual
Z-SG2 / Z-SG2-L
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc: MI-005370-EN
Rev. 1.0.0.2
Page 6
INTRODUCTION
ATTENTION!
This user manual extends the information from the installation manual to the configuration of the
device. Use the installation manual for more information.
ATTENTION!
In any case, SENECA s.r.l. or its suppliers will not be responsible for the loss of data/revenue or
consequential or incidental damages due to negligence or bad/improper management of the device,
even if SENECA is well aware of these possible damages.
SENECA, its subsidiaries, affiliates, group companies, suppliers and distributors do not guarantee that
the functions fully meet the customer's expectations or that the device, firmware and software should
have no errors or operate continuously.
DESCRIPTION
Z-SG2 is a load cell converter (strain gauge). The measurement, carried out with the 4 or 6-wire technique, is
available via the MODBUS-RTU serial protocol or via the fully configurable analogue output.
The device is equipped with a new noise filter specifically developed to obtain a rapid response time. The
device is fully configurable via the USB or RS485 ports using the Easy Setup configuration software.
Compared to its predecessor, it offers a new anti-noise filter and numerous new features, dramatically
increasing product performance.
Model
Description
Communication protocol
Z-SG2
Strain Gauge converter with digital
input/output and analogue output
Modbus RTU Slave
Z-SG2-L
Strain Gauge converter with digital
input/output
Modbus RTU Slave
