ENGLISH 7/8
MI003651-E
Default Conditions
Module factory settings parameters:
SW1 Switch position
ON
LED Signallings
LED
STATE
Meaning of LEDs
PWR Green
On
The module is power on
Stop/Run
On
The module is ready for use
Fault Red
On
O.S. boot loading
Run1-2 Yellow
Blinking
There is data activity (Ethernet 1-2)
Lnk1-2 Green
On
Ethernet 1-2 connection detected
TX1-2-3 Red
Blinking
Signaling Data Transmitting (COM 1-2-3)
RX1-2-3 Red
Blinking
Signaling Data Receiving (COM 1-2-3)
TX1-2-3 Red
On
Verify the connection (COM 1-2-3)
RX1-2-3 Red
On
Verify the connection (COM 1-2-3)
Plug-in Connector for Micro SD Card
Micro SD card
The Z-TWS5 has a slot for micro SD
card placed on the side of the case
Before pushing the SD card in this slot,
please be sure that the SD card metal
contacts are facing towards left (Please
see the figure on side).
SD card
metal
contacts
Micro SD Card
DIP-Switch SW1
ON RS485 COM2
OFF CANopen COM0
On the module side there are one switch.
With this switch you can choose between
RS485 or CANopen serial interfaces,
from screw terminals 1-2-3 or from the
rear side 10 pin connector.
We suggest
to turn off the module before setting
the switches.
