Seneca S6001-RTU, User Manual

Page: 56 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
56
5) switch on the Device; the upgrade procedure will take some minutes to be completed; during this
time, the Device MUST NOT be switched off; during the procedure, the Device will be rebooted
several times; also, during the procedure, several LEDS will blink simultaneously
8
6) the upgrade procedure is ended when only the LED “RUN” is blinking
9
7) remove the USB pen
18 Web Configuration Pages
NOTE: in this chapter, the web pages screen-shots are shown for only one of the products (Z-TWS4, Z-
PASS2-S, Z-PASS2-S-R01, Z-PASS2-S-IO, S6001-RTU); the pages for the other products are identical, except
for the product name shown in the top of the pages and for some details explained in the following
paragraphs.
Furthermore, for S6001-RTU one more page (“I/O View”) is available.
18.1 Administrator pages
The Device can be fully configured by means of a set of web configuration pages.
To access the Device configuration site, you have to connect the browser to the Device IP address on port
8080, e.g.:
http://192.168.90.101:8080
10
and, when asked, provide the following credentials (default values):
Username: admin
Password: admin
You come to the “Main View” page, described in the following paragraph.
8
This applies only to products with HW revisions IO and R01; in details: for IO HW revision, all LEDs will blink
simultaneously, except for Power, LAN/WAN, COM and modem LEDs; for R01 HW revision, RUN, VPN and SERV LEDs
will blink.
9
Also SERV and VPN LEDs might blink, depending on the Device configuration and status.
10
The default 80 HTTP port has been left available for customer pages.