3/3
INSTALLATION NTC-150
ATTENTION
Turn off the power supply before wiring.
1 2 3
4 5 6 7 8 9 10 11 12
-
+
13
Before proceeding with the installation of the NTC-150 external probe it is necessary to remove the NTC probe
supplied with the control unit. Simply cut or remove the probe on the back of the control unit.
Once the pre-installed probe has been removed, connect the NTC-150 probe by wiring the cables to the Moretti
12 and 13 as shown in the figure below.
CONTACT INFORMATION
Technical support
Product information
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
