Seneca MyBoat-WR, User Manual

Page: 6 / 34

6 MI005220-E
MyBoat
_WR
• Do not apply different voltages or higher voltages than indicated between
terminals, or between any terminal and earth (voltages greater than 50Vdc)
• Do not use the MyBoat-WR control unit if damaged, or if signs of possible
damage are visible on it.
• Do not remove the internal battery.
• Do not use the MyBoat-WR control unit if it runs abnormally.
• Do not touch the MyBoat-WR control unit terminals during use
• For correct use, use the cables supplied.
• Make sure the internal battery is charged if you intend to use the My-
Boat-WR control unit without power
• Use the MyBoat-WR control unit as described in this manual.
• Before each use, refer to the electrical connections shown in the manual.
REFERENCE STANDARDS: ETSI EN 301-489-7
EN 301 511
EN 301 498-1
IEC / EN 60950
CAUTION
WARNING
1 - WARNINGS SAFETY REGULATIONS
Electrical and electronic waste disposal (applicable in the European Union and other countries
with selective waste collection). The symbol on the product or packaging shows that the
product should be taken to an authorised recycling centre for electrical
and electronic waste.
The full content of this manual must be read before any operation. The device is to be exclusively
used by qualified electricians.
Damaged parts must be replaced or repaired
by the manufacturer. The product is sensitive to electrostatic discharge, take
the appropriate countermeasures during any operation.
The warranty expires in case of improper use or tampering with the device or
accessories supplied by the manufacturer, necessary for its correct operation and if
the instructions in this manual have not been followed.