ENGLISH 5/8
MI004323-E
CONSTRUCTIVE ELEMENTS OF MYALARM2
AUTO POWER-OFF
. If the MyALARM2 displays «LOW BATT», its internal battery is running
low: after 60 seconds, the MyALARM2 turns off automatically. To recharge the battery to an
appropriate value, power on the MyALARM2 using one of the recommended cables.
POWER SUPPLY BY USB CABLE
. The MyALARM2 power supply that uses USB port is not
suitable for permanent installations, or installations in which are used relays and/or digital
inputs. In these cases, supply the MyALARM2 using the 12 Vdc-power supply (it is an
included element).
Note about the MyALARM2 functioning
The MyALARM2 has the PWR button,
placed in the upper left side (front
view). Pressing of this button allows to
power on / off the module. To power off
the module, keep pressed the PWR
button for a few seconds.
Moreover the MyALARM2 has the
SCR button, placed in the upper right
side (front view). Pressing of this
button allows to scroll the display
parameters.
Button for power on / power off and button for settings
PWR
SCR
ANTENNA
USB port and power supply
The MyALARM2 has a micro USB plug
in, placed on the left side of case: it can
be used to configure the MyALARM2,
to perform the firmware upgrading and
to recharge the internal battery from
PC.
In alternative, it is possible to recharge
the internal battery, using:
- the power supply (an accessory, no
supplied with MyALARM2) using USB
plug in or, in alternative
- the 12 V - power supply (supplied with
MyALARM2), connecting wires with
ter and - (GND).
ANTENNA
micro
USB
The MyALARM2 is delivered in "shipping mode".
In this way the battery isn’t unnecessarily discharged
during storage and shipping.
When you turn ON the MyALARM2, for the first time, apply power externally by Usb
port or by the included power supply. Please don’t use the PWR button.
Following this procedure the MyALARM2 can exit from “
shipping mode
”.
Warning:
for the first time, the device must be supplied
When you turn ON the MyALARM2
without any interruptions for at least 4 hours in order to charge the internal batteries.
