SAFETY INFORMATION
ENGLISH - 5/8
1 2 3
4 5 6 7 8 9 10 11 12
-
+
13
MyAlarm SEAL
has a terminal block inside its enclosure.
To access the internal terminal block of the device, unscrew the screw at the
centre of the black cover positioned at the bottom of the enclosure and lift up.
In the side figure, the cover has been removed.
IMPORTANT:
With the relay card, mobile wirin g of cables connected to
terminals is not permitted. To make the cables from the terminals safe, use the
break-out passages in the back of the enclosure. When the wiring is complete,
fasten the protective cover on the device with the screw to prevent any
accidental contact.
ASSEMBLY STANDARDS
For optimum reception of the GPS signal from satellites, it is best to place the MyAlarm SEAL in an area not
covered by metal structures.
If this is not possible, an optional external antenna with 3m cable (code AGPS) is
available. Follow the procedure supplied with the package for the installation of the external antenna.
INSTALLATION ON IEC EN 60715 DIN RAIL AND WALL FIXING
Insertion on DIN rail
:
1) Insert the three hooks of support for DIN rail into the three
holes in the rear side of the MyALARM
and fix the device to
2-
3
the support.
2) Hook support and device to the CEI EN 60715 DIN rail.
Wall mounting
:
1) The two holes on the support for DIN rail allows to fix it to the
wall with included plugs and screws.
2) Fix the device on the support to the wall by the three holes in
the rear side of the case.
INSTALLATION RULES
The device can be installed on a wall or on a DIN rail EN 60715, in vertical position.
Never place this device inside metal cabinets or near heat sources.
