Sencore S8100, Instruction Manual

Page: 27 / 56

Small pieces of mineral materials may be ejected from the cutting groove by the quick rotation of the cut off wheel.
• Rotate the wheel guard down as far as possible so the cut particles are ejected away from the user.
• Mark the cutting line and grind a groove of approx. 5 mm [approx. 3/16”] along the entire line at half throttle that will
guide the power tool precisely for the subsequent cutting process.
• Perform the cutting process with even movements back and forth.
• When fitting stone plates, application of a flat groove is sufficient (avoiding unnecessary dust formation), to then
cleanly strike off the protruding piece on a flat support.
8 Operating and maintenance notes
Maintenance and repairs of state-of-the-art power tools and their safety-relevant assemblies require qualified specialist
training and a workshop equipped with special tools and test devices.
Recommendation: Have all work not described in these operating instructions and all work you are not comfortable
with be performed by a specialist workshop authorized by us. The specialist has the required training, experience and
equipment and can make the most cost-efficient solution available to you. He will advise and support you.
The power tool must be cleaned thoroughly after every use and checked for damage; in particular the cooling air
openings in the starter housing must be clean and free.
Inside the wheel guard, material deposits will form over time (in particular when wet cutting), which may impair free
rotation of the cut off wheel.
Only use the environmentally compatible cleaning agents offered by specialist vendors for cleaning. Never use fuel to
clean!
It is best to keep the power tool in a dry and safe site with a full fuel tank.
There must not be any open sources of fire or the like nearby.
Before extended storage (> 4 weeks), observe the notes in chap. 8.10 on page 35
• Disassemble cut off wheel and outer mounting flange.

Chap. 5.3, page 17
• Remove material deposits inside the wheel guard with a wood bar or similar.
• Clean spindle and all disassembled parts and check them for damage.
• Clean cut off wheel and check it for damage. If any damage is found, dispose of the cut off wheel properly and
immediately so that it is not reused in the next work deployment.
• Inspect the wheel guard for damage. If damaged, replace the wheel guard by an undamaged wheel guard before
using the power tool and dispose of the damaged wheel guard properly and immediately.
• Install outer mounting flange, any other parts and cut off wheel again.

Chap. 5.1, page 16
Observe the safety provisions for any maintenance work!
After a run-in time of approx. 5 operating hours, all screws and nuts that can be reached (except for
carburetor adjustment screws) must be checked for tight fit and tightened again if required.
8.1 Cleaning and Care
SENCORE S8100 CUT-OFF SAW MANUAL 27