Sencor SWS 12500, User Manual

Page: 9 / 72

EN – 7
SETTING UP THE METEOROLOGICAL SERVER CONNECTION
Please enter the following information in the web interface “SETUP” page shown below
If you decide to use neither
Wunderground.com
nor
Weathercloud.net
, please leave the
check boxes blank.
Press to display the extended settings.
Enter the longitude value
Press to enable adding
a router manually
Press to search for
a router
Enter the latitude value
Changing the UI interface language settings
Select the (Wi-Fi network / SSID) you wish to connect to
Enter SSID manually if it’s not listed
Select the router safeguarding type (usually WPA2)
Router password (leave blank if unsecured)
Enter the new Station ID and Station key assigned by the
Wundeground service
Enter the new Station ID and Station key assigned by the
Weathercloud service
Reserved for a verified meteorological server, for details, please
contact your dealer
Enter the new Station ID and Station key assigned to the
corresponding meteorological servers
Select a time server
Select the time zone to place your Weather station.
Select the direction of your Weather station placement
Select the placed sensor’s hemisphere (for example, USA
and EU countries are also “N”, Australia is “S”)
Press to finish the settings.
NOTE:
•
Your default WI-FI connection will be restored when the Weather station’s WI-FI setup
has been completed.
•
To stop the AP mode and restore previous settings in the AP mode, you can hold
down the
[SENSOR / WI-FI]
button for 6 seconds.
Time zone: To display your time zone current time, change the time zone in the time setup
mode from “00” (default) to your time zone (such as 08 for Hong Kong).
The time will be synchronized automatically from the internet time server, each day
at 12:00 and 24:00. To get the internet time manually in 1 minute, you can also press
[REFRESH]
button
TIME SERVER CONNECTION STATUS
When the device has been connected to the internet, it will attempt to connect to the
internet time server and get the UTC time If this connection is successful and the device
clock is updated, the LCD display will show “ SYNC “ (synchronization) icon.