EN
Vacuum cleaner
SVC 730RD / SVC 730GR
05/2012
ASSEMBLY
Inserting the hose
6
into the air suction hole on the vacuum cleaner.
Press the safety button on the hose end and insert the hose end into the air suction hole on the
vacuum cleaner until you hear „click". The hose is now secured in correct position.
Place the holder
7
on the telescopic tube
9
Make sure to install the holder on the wider part of the telescopic tube.
Install the fl oor inlet nozzle
0
on the telescopic tube
9
Make sure to install the fl oor nozzle on the narrower part of the telescopic tube.
Adjust the length of the telescopic tube
9
as needed.
Adjust the length of the telescopic tube as follow: Move and hold the button on the tube forward as
shown by arrows and adjust the length of the tube as needed. Release the button and move the tube
little bit forward until you hear „click". The telescopic tube is now securely set in position.
USING YOUR VACUUM CLEANER
Connecting your vacuum cleaner to power source - wall outlet
Pull the plug of the supply cable from the vacuum cleaner until the desired length of the cable is out
of the appliance. Insert the plug to the wall outlet.
Warning:
Yellow marking on the supply cable tells you that the cable is close to its end. Do not pull the
cable more than to the red marking.
Adjusting the fl oor inlet nozzle
0
according to the fl oor surface.
You may set the inlet nozzle according to the fl oor surface by adjusting the inlet fl ap:
•
If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning
the fl ap accordingly.
•
If you want to vacuum hard and smooth surface, move the bristles out of the nozzle, by turning
the fl ap accordingly.
Turning your vacuum cleaner on and off
To switch your machine on and off, press the START / STOP button
1
on the vacuum cleaner body.
Adjusting the suction strength
8
The suction strength may be adjusted by moving the rider on the appliance body ( small range) or by
the moveable rider
6
on the hose handler.
Tip:
If the hose holder
7
on the hose
6
gets clogged during vacuuming, disconnect it from the
telescopic tube
9
and also disconnect the hose
6
from the vacuum cleaner body. Then place the
holder
7
inside the suction hole on the vacuum cleaner body and vacuum the stuck dirt out.
Temporary interruption of the vacuuming process
If you want to stop the vacuuming process temporarily, place the telescopic tube
9
in the parking
position on the rear of your appliance, using the notch on the fl oor inlet nozzle
0
Warning:
Do not move the appliance from place to place if the hose is in the parking position! You may
break the parking position holder!
