Electric Slicer & Grater
SSG 3500WH / SSG 3501GR / SSG 3502BL / SSG 3503OR / SSG 3504RD
SSG 3505VT / SSG 3506YL / SSG 3507TQ / SSG 3508RS
EN
EN-9
2015
01/2015
3 . Before you start inserting food into the feed tube A
2
, press the switch A
6
once or twice to ensure
that the attachment is properly seated on the shaft . Then hold down the switch A
6
and start to
gradually insert food into the feed tube A
2
. Use the pusher A
1
to push food through the feed
tube A
2
.
Attention:
Do not use your fingers other items to push food in . Always use the pusher A
1
designed for
this purpose .
The maximum continuous operating time is 2 minutes . Before turning it on again, allow the
appliance to cool down for at least 3 minutes .
4 . To turn off the appliance, release the switch A
6
. When you have finished using it, disconnect the
appliance from the power socket and clean it out according to the instructions contained in the
'Cleaning and maintenance' chapter .
USEFUL TIPS
•
Check the suitability of the individual attachments for specific food types in the 'Attachment type
selection' table .
•
To achieve the best possible results, process fresh not overly ripened fruit . The same applies to
vegetables .
•
You can place softer fruit such as strawberries into a freezer for a few minutes .
•
Semi-hard cheese will be processed better if you place it in a refrigerator overnight or in a freezer
for 30 minutes .
•
We do not recommend processing soft or already grated cheese as this could clog up the chamber A
3
.
•
If you are using the fine grater A
qs
or the thin slicer attachment A
9
then push the food through
the feed tube A
2
gently . When using the coarse grater A
qa
or the thick slicer A
0
, it is necessary
to push food through with greater force .
•
This appliance is not designed for processing meat or types of food that are too hard to be cut with
a kitchen knife .
TROUBLESHOOTING
•
This table shows situations that may arise when using the appliance . If the table does not help you
in resolving your problem, please contact an authorised service centre .
Problem
Possible solution to the problem
When the switch A
6
is pressed
and held down, the appliance
runs only intermittently or it
does not start up at all .
Turn off the appliance and disconnect it from the power socket and
wait for the rotating parts to come to a stop . Check that you have
assembled the appliance correctly according to the instructions in
the 'Assembling and disassembling the appliance' chapter .
The chamber A
3
becomes
clogged during operation .
Pieces of food could have stuck to the attachment and clogged
the chamber A
3
. If this happens, turn off the appliance and
disconnect it from the power socket and wait for the rotating
parts to come to a stop . Remove the attachment and the chamber
A
3
. Then clean it out according to the instructions in the
'Cleaning and maintenance' chapter .
A greater force is needed to
push food through the feed
tube A
2
.
Harder types of food such as potatoes or hard cheese need to
be pushed through the feed tube A
2
with greater force . This
is completely normal . Take a three minute break after every
2 minutes of operation .
