- 11 -
08/2020
Copyright © 2020, Fast ČR, a.s.
Attention:
Do not wash the dust container or the dust filter in a dishwasher.
Before putting the vacuum cleaner back into operation, check
that the dust filter is in its location. Otherwise the vacuum cleaner
may be damaged.
■
Assemble all the parts to the initial state and slide the dust container back into the
vacuum cleaner.
WATER TANK
■
We recommend that water is poured out of the water tank
A4
and the tank is cleaned
after every wiping of the floor.
■
Press latch
D1
to slide the water tank out from the vacuum cleaner and then remove
the holder
D3
with the mop fabric
D4
from the water tank.
■
Flip open the rubber cap
D2
and pour out any remaining water.
■
Use a damp cloth to wipe the entire tank and allow it to dry naturally. Do not expose
the water tank to direct sunlight while drying it.
Attention:
Do not wash the water tank, holder or mop fabric in a dishwasher.
MOP
■
After every dry or wet wiping, remove the mop fabric from the holder, wash it by hand
in lukewarm water with the addition of a small amount of gentle washing powder and
allow it to dry naturally.
■
Wipe the mop holder with a lightly dampened cloth or wash it under running water
and then dry thoroughly.
CENTRAL ROTARY BRUSH
■
Push on the latches
F1
of the central rotary brush cover
A21
and take out the cover.
■
Take out the rotary brush
A22
.
■
Use a dry wiping cloth to clean out the area in which the rotary brush is housed. Also
clean the suction hole, the procedure is described later in this user's manual.
■
Remove any dirt and material (dust, wound on hair, animal fur, etc.) from the brushes
F2
of the rotary brush and also from the ends
F3
. You can cut heavily wound on hair
using the blade of the cleaning brush
E2
.
■
Reinsert the rotary brush and its cover.
Attention:
In the event that an excessive amount of dirty material
accumulates on the central rotary brush and in its compartment,
there is a risk of permanently damaging the vacuum cleaner.
Regularly inspect the condition of the brush.
Do not use the vacuum cleaner without the central rotary brush.
SUCTION HOLE
■
The suction hole is located underneath the central rotary brush, therefore, take it out
before cleaning the suction hole as described in the previous chapter. With repeat
use, dust and dirt may accumulate around the suction hole, which may manifest itself
through decreased suction efficiency. Remove the dirt and dust from the suction
hole using a soft brush. Regularly clean the suction hole to ensure maximum suction
power.
SIDE ROTARY BRUSHES
■
Take out the rotary brushes by pulling them upwards. Remove any dust and dirt from
the location where the brushes were mounted.
■
Remove all dust and dirt from the brushes. If necessary you may wash the brushes
under running water. If the bristles were deformed while the vacuum cleaner was
running, dip them in warm water to allow them to return to their original shape. Allow
the brushes to dry before reattaching to the vacuum cleaner.
■
After cleaning it, reattach it.
Note:
The rotary brushes become worn out when used. After a certain time it
is necessary to replace the used brushes with new ones. To order new
brushes, contact your vendor or an authorised service centre.
COMPLETE ROBOTIC VACUUM CLEANER
■
Regularly wipe the surface of the vacuum cleaner using a soft dry wiping cloth.
■
First remove any coarser dirty material from the front swivel wheel
A18
and the
motorised wheels
A13
and
A20
. Then clean them around their entire perimeter using
a lightly dampened cloth and wipe them dry. Do not forget to also clean the area
around the wheels.
■
At least once per week, or more often, wipe the sensors
A9
,
A12
,
A19
on the
underside of the vacuum cleaner and the side sensor
A8
using a soft dry wiping cloth
or a cotton bud.
CHARGING STATION
■
At least once per week, clean the surface of the charging station
B1
including the
charging contacts
B2
using a soft dry wiping cloth.
STORAGE
When not using the vacuum cleaner for an extended period of time, do the following:
■
Turn off the vacuum cleaner by setting the main switch to the OFF position.
■
Clean the vacuum cleaner as described in chapter CLEANING AND MAINTENANCE.
■
Disconnect the charging station from the power socket.
■
Store the vacuum cleaner with all its accessories in a dry, clean and cool place.
TECHNICAL SPECIFICATIONS
Robotic vacuum cleaner
Dimensions (diameter × height) ......................................................................................340 × 90 mm
Weight ........................................................................................................................................................... 3 kg
Motor power output ..............................................................................................................................40 W
Operating time per single charge.....................................................................................up to 90 min
Dust container capacity ....................................................................................................................250 ml
Water tank capacity ............................................................................................................................350 ml
Vacuuming system ....................................................................................... SUPER SUCTION 4 000 Pa
Navigation system .......................................................................................................... Sencor Nav. 16.0
Power adapter
Input ..........................................................................................................100–240 V AC, 50/60 Hz, 0.2 A
Output..........................................................................................................................................5 V, 1000 mA
Battery
Type ......................................................................................................................................2,600 mAh Li-Ion
Charging time ..........................................................................................................................................4–6 h
Input .........................................................................................................................................................5 V, 1 A
The declared noise emission level is lower than 70 dB(A), which represents a level A of
sound power with respect to a reference sound power of 1 pW.
DISPOSAL OF USED BATTERIES
Prior to handing over the product at a specialised collection facility, it is necessary to
ensure that the battery is removed. Prior to removing the battery, turn off the vacuum
cleaner using the main switch. Disconnect the battery according to the procedure
described in chapter REPLACING THE BATTERY.
This symbol indicates that used batteries do not belong in ordinary
municipal waste. Hand over used batteries to designated collection
points for proper disposal. Correct disposal of batteries will help prevent
negative impacts on the environment and human health.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of
used batteries, request the necessary information about the correct
disposal method from the local authorities or from your vendor.
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL
OF USED PACKAGING MATERIALS
Dispose of used packaging material at a site designated for waste in your municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that used electric
or electronic products must not be added to ordinary municipal waste.
For proper disposal, renewal and recycling, hand these products over to
determined collection points. Alternatively, in some European Union
states or other European countries you may return your appliances to
the local retailer when buying an equivalent new appliance.
Correct disposal of this product helps save valuable natural resources
and prevents potential negative effects on the environment and human
health, which could result from improper waste disposal. Ask your local authorities or
collection facility for more details.
In accordance with national regulations penalties may be imposed for the incorrect
disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electric or electronic devices, ask your retailer or supplier for
the necessary information.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this product, request
the necessary information about the correct disposal method from the local council or
from your retailer.
This product meets all the basic requirements of EU directives related to it.
