EN-8
EN
Hair Clipper
SHP 211SL
2019
07/2019
Tip:
When cutting hair, move the hair clipper against the direction of hair growth and follow the
contours of the head.
If you are using the hair clipper for the first time, we recommend that you first use attachment B
3
or
B
4
. If you feel that the haircut is too long, you can select a different attachment for a shorter haircut.
Before trimming the hairline on the neck and around the ears, remove the comb attachment
B
1
, B
2
, B
3
or B
4
from the cutting unit A
1
. Turn the hair clipper so that the blade of the
cutting unit points downwards and slowly trim the hair going from the top downwards.
Note:
When cutting, some hair may accumulate between the blade of the cutting unit and the comb
attachment.
To remove the hair accumulated between the blade of the cutting unit A
1
, press lever A
2
up
and down several times.
To remove hair accumulated in the comb attachment, first turn off the hair clipper by moving
switch A
4
to the OFF position. Then remove the attachment and clean it.
•
After finishing the haircut, turn the hair clipper off by moving switch A
4
to the OFF position and
disconnect the power plug A
6
from the electrical power socket.
•
After each use, clean the hair clipper according to the instructions included in chapter Cleaning and
maintenance.
CLEANING AND MAINTENANCE
•
Before cleaning the hair clipper, turn it off and disconnect it from the el. power socket.
•
Release the comb attachment from the cutting unit A
1
by pressing downwards on the heel of the
attachment C
2
and remove it from the cutting unit A
1
.
•
Clean the comb attachment B
1
, B
2
, B
3
or B
4
and the cutting unit A
1
using the cleaning brush B
8
.
•
Wipe the body of the hair clipper A
3
using a clean dry cloth.
•
Do not use thinners, solvents, cleaning agents that cause abrasion, etc. to clean the product.
Attention:
Keep the hair clipper dry. Do not spray it with water or submerge it in water or another
liquid.
LUBRICATING THE CUTTING UNIT
•
We recommend that you regularly lubricate the cutting unit A
1
always after several uses.
•
If the comb attachment B
1
, B
2
, B
3
or B
4
is attached to the cutting unit A
1
, remove it.
•
Apply one to two drops of oil B
7
to the blade of the cutting unit A
1
and evenly spread the oil
using a cloth. Dry off excess oil. Check that the blade is clean before using again.
Note:
After using up the supplied oil B
7
you can use an oil that does not contain acids, e.g. sewing
machine oil.
