EN-8
EN
Pedestal Fan
SFN 4040SL
2019
12/2019
DESCRIPTION OF THE APPLIANCE
A1
Protective grille (consists of two parts: front and rear)
A2
Fan blades with a diameter of 40 cm
A3
Motor unit
A4
Horizontal oscillation toggle switch
A5
Speed selector 0 - off, 1 - low speed, 2 - medium speed, 3 - high speed
A6
Screw for attaching the motor unit to the pole
A7
Fan head tilt angle adjustment screw
A8
Extensible pole
A9
Pole extension lock
A10
Base
Note:
The accessories include a screw and a nut for joining the protective grills .
BEFORE FIRST USE
■
Take the appliance and its accessories out of the packaging materials . Before disposing of the packaging materials,
make sure that no part of the appliance is missing .
ASSEMBLING AND DISASSEMBLING THE APPLIANCE
■
Before assembling or disassembling the appliance, make sure that it is turned off and disconnected from the
power socket .
■
Remove the nut from the underside of the extensible pole
A8
. Seat the extensible pole
A8
on the base
A10
so that
the opening of the extensible pole
A8
is aligned with the hole in the base
A10
. Secure the extensible pole
A8
in
place using the nut . Check that it is correctly tightened .
■
Remove the four screws
A3
from the motor unit . Place the rear part of the protective grille
A1
on to the motor unit
A3
so that the holes in the motor unit
A3
are aligned with the holes in the protective grille
A1
. Secure the rear part
of the protective grille
A1
using the screws .
■
Place the fan blades
A2
on to the shaft of the motor unit
A3
and firmly tighten the screws .
■
Now attach the front part of the protective grille
A1
and fasten both parts together using the metal clamps and
a small screw, which is a part of the grille assembly .
■
Place the motor unit
A3
with the attached fan head on the extensible pole
A8
and secure the fan head using the
screw
A6
.
■
Before putting the fan into operation, check that it is correctly assembled and that the protective grills are firmly
joined .
■
To disassemble, proceed in reverse sequence .
OPERATING THE APPLIANCE
Setting the speed and turning off the fan
■
Place the fan on an even, dry and smooth surface within reach of a power socket . Connect the power cord to
a power socket . To set the air flow speed, use the speed selector
A5
.
0 – turn off the fan;
1 – set a low air flow speed;
2 – set a medium air flow speed;
3 – set a high air flow speed .
■
When you have finished using the fan, always turn it off and disconnect it from the power socket .
Setting horizontal oscillation
■
The horizontal oscillation of the motor unit
A3
can be set using the toggle switch
A4
. To start the horizontal
oscillation, push the toggle switch
A4
down . The motor unit
A3
will oscillate from side to side at an angle of
approximately 90° .
■
To turn off the oscillation, pull the toggle switch
A4
up . This will turn off the oscillation .