Senco LNS 3215 E, Operating Instructions Manual

Page: 8 / 47

7
6. If necessary, place palm of free hand on top
of the tool to achieve better penetration.
7. Always disconnect the tacker from the power
supply after use.
8. Penetration adjustment
Turn adjusting knob left to lower (A)
And right to raise (B).
8. Clearance of jamming
In the event of malfunctions caused by jammed staples or nails proceed as
follows:
1. Disconnect main plug
2. Release latch and slide open the magazine.
3. Grad jammed fasteners with pliers and
remove.
9. Maintenance
¦ Disconnect main plug and unload the magazine.
¦ Clean the magazine space, guide plate and other active parts with a jet of
compressed air.
¦ It is recommended to put one drop of machine oil on the driver slide area. Do
not lubricate the internal parts of the tacker.
¦ Never use solvent or other liquids in cleaning this tool.
¦ Do not use or keep the tacker in wet or dusty locations.
¦ Do not disassemble or alter the tacker. All defective or non- working
machines should be repaired only by fully trained technician.