Senco LNS 3215 E, Operating Instructions Manual

Page: 7 / 47

6
Loading instructions:
1.Disconnect power source.
2. Unlock the magazine by releasing latch
in the back, and slid-open the magazine.
Fig. B
A. Loading nails:
3. Load selected nail strip (nail points facing
downwards) into the track of the magazine – the
head of he nail can go above and below the locating
rails. Fig. D
4. Push the track back until release latch clicks. (A click
sound from the latch indicates it has been locked
properly.) Fig. E
B. Loading staples :
5. Place the tool upside-down, and load staple strip in
magazine rail so that the crown of the staple (top flat
part) is in the uppermost of magazine. Fig. F
6. Push the track back until release latch
clicks. (A click sound from the latch
indicates it has been locked properly. Fig. G
7. Operating instructions
1. Turn the power switch in “OFF” position (O).fig. A
2. Plug tool into 220-240V~50Hz power outlet.
3. Grip the tool firmly and hold against work piece.
4. Turn the power switch in “ON” position.
5. Press the safety yoke hard enough to activate
trigger.