3-27
3-6 Configure Routing Table
1. Click
Advence Config
and select the
Static Route
page. This page (as
shown in
Figure 3-23
) will present the current configuration for the
routing table. You can also click
ADD, DELETE
or
MODIFY
button to
maintain the
Static Routing table
(Default
Routing table
only contain
single routing entry:
Default Route
entry).
2. Every
Route entry
contains three parameters:
Network Address,
Subnet Mask
and
Gateway
.
Network Address
and
Subnet Mask
: Specify the destination network.
Gateway
: Indicate the forward gateway.
3. After that, click
FINISH
at the bottom of this page to complete the
modification of this page.
Hint:
The operator must to configure correct routing settings following the
network infrastructure.
Figure 3-23
3-28
3-7 Configure Bridge
1. Click
Advence Config
and select the
Bridging,
and then click
Enable
for
Bridge Function
as shown in
Figure 3-6
. In the
Bridging
Parameter
window, enter the
IP Address
(default is
192.168.2.1
) and
Subnet Mask
(default is
255.255.255.0
) that are suitable for your
network domain.
2. You can specify the MAC address of a Wireless/Ethernet client. All MAC
entries in the MAC address table are Permitted/Blocked/Learning to
connect to the RB. In here, you can also click
ADD, DELETE, MODIFY
button to maintain this MAC address table.
3. After that, click
FINISH
at the bottom of this page to complete the
modification of this page.