FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance. The antenna used for this transmitter
must not transmit simultaneously with any other antenna or transmitter, except in accordance with FCC multi-transmitter
product procedures.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could
void user’s authority to operate the equipment.
Industry Canada Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
WEEE (Waste Electrical and Electronic Equipment)
The crossed-out wheel bin symbol on the product, literature, or packaging reminds you that all electrical and electronic
products, batteries, and accumulators must be taken to separate collection at the end of their working life. This
requirement applies to the European Union and other locations where separate collection systems are available. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, please do not dispose of
these products as unsorted municipal waste, but hand it in at an official collection point for recycling.
DOT Certification
This product conforms to the DOT FMVSS 218 (US) helmet safety standards as defined by the United States
Department of Transportation Federal Motor Vehicle Safety Standard. This certification applies to the United States of
America. The approval label can be affixed permanently to the outside of the helmet (United States, Argentina, Australia
and others). Do not remove or attempt to remove the approval label from the helmet. Do not affix approval labels of
unknown origin to the helmet. These are more than likely counterfeit labels. It is against the law to affix counterfeit
labels to helmets. If you are in any doubt over the origin of the approval label affixed to your helmet contact Sena
directly, and not your dealer.
Product Warranty and Disclaimer
Limited Warranty
Sena Technologies, Inc. (“Sena”) guarantees the product quality based on the technical specification stated in the
product manual, and data regarding product warranty. Here, product warranty extends to the product only. Sena will
not be liable for any loss, damage of human life, or loss of property which may result from using the product beyond
defective parts or flaws that occur due to problems in manufacture.
Summary of Contents for SP49
Page 8: ......
