20
This menu make easy pairing configuration of Parani-ESD that hasn’t pairing button. Although this
menu can be used to pairing configuration of Parani-SD that has pairing button, pairing configuration
by pairing button is recommended. To use this menu, follow next steps.
Step 1.
Connect the first SD and then push the START button.
Step 2.
Disconnect the first SD, connect the second ESD and then push the Next button after setting
up Slave configuration. At this time, the dip switch value should be ATcommand mode. The flow
control setting can be changed only through dip switch.
Step 3.
Disconnect the second SD, once again connect the first ESD and then push the Finish button.
The pairing configuration finished. Make sure that each SD’s connect LED is on. From now, when
the SD restarts the pairing connection will be established automatically.
3.3.8. ParaniUpdater
Parani-SD support firmware update. You can download new firmwares of Parani-SD at
http://www.sena.com
. With ParaniUpdater, you can update firmware of Parani-SD by selecting the
firmware image file and pushing Start button.
* Note: DO NOT power off Parani-SD while the firmware update is progressing. It may damage the
firmware seriously.
Figure 3-12 ParaniUpdater Window
.
3.3.9. Terminal Program
A terminal program is an application that will enable a PC to communicate directly with a modem. If
you are using Windows 98SE or higher version of Windows, HyperTerminal program as it is included
as part of the operating system. Parani-SD provides some extended AT commands for its
configurations on terminal program.
This manual will explain the method using HyperTerminal. If you need to install HyperTerminal, click
start>setting>control panel>add/remove programs. For more precise information, please refer to Help
of Microsoft Windows.
