Installation
Cradle
Main body of the Product
Rear view mirror
•
Install the product as shown in the picture on your left. Mounting of the cradle on heating wire may cause
damage to the wire during later disassembly, to which you need to pay attention.
•
Be sure to wipe the foreign matter or dust cleanly off the area where the product is attached with double-sided
tape.
micro
SD card
1.
Insert the micro SD card into the side of the product, as shown in the figure.
•
Be sure to use only the memory card recommended by us.
•
Check the direction of the SD card before you insert it.
•
Make sure that the micro SD card be inserted before you fix it in the cradle.
50mm
1
3
2
2.
Remove the tape liner of the back of the cradle before you attach it on the windshield behind the rear view mirror
of the vehicle. You are advised to leave a space of about 50mm from the support of the rear view mirror.
Mount the product in the cradle and connect the power cable.
It should be noted that not securing a space of 50mm at the time of installation of the cradle will result in
difficulty in mounting/dismounting the product.
12
