SELWOOD SELTORQUE S150, Manual

Page: 1 / 62

Selwood Seltorque S150 Manual
1
SELWOOD SELTORQUE S150
Model Designation
From the 1st January 2004 the Seltorque 150C will be
known as Seltorque S150.
Operating and Service Manual
The products of Selwood Limited, are designed,
developed and produced in the company's Chandler's
Ford factory. Many features are covered by world-
wide patents. Product names such as Spate, Simplite
and Seltorque, are registered trade marks.
As all products are subject to continuous development,
the company reserves the right to alter the
specifications and information given in this manual
without prior notice.
Whilst every care has been taken in the preparation of
this publication the information it contains must not be
regarded as binding.
Amendments to this publication will only be issued to
cover those design changes which fundamentally alter
the build or operation and servicing procedures. They
will be distributed through the company's dealers and
agencies.
Published by Selwood Limited.
© Selwood Limited 2004
Instructions for Ordering
Replacement Parts
1. Always quote the pump serial number located on
the plate fastened to the bearing and air pump
mechanism housing.
2. Always quote the part number(s) (ten digit) of the
component(s), NOT the item number(s).
3. Always quote the description of the component(s).
Items usually supplied together as sub-assemblies will
have the sub-assembly part number printed at the
bottom of the relevant page.
Additional copies of this manual may be ordered from
Selwood Limited, Pump Division, by quoting the
publication number shown on the outside back cover.
HEALTH AND SAFETY AT WORK
April 1975
As manufacturers of pumps and associated equipment
we wish to inform you that, in compliance with Section
6 of the Act, safety precautions should be taken with
our products.
We take every care to ensure as is reasonably
practicable that our products are safe and without risk
to health when properly used. Nevertheless,
appropriate health and safety precautions must be
taken, and in particular you are requested to have
special regard to the operational and safety
requirements leaflet P769 which accompanies each
pump on despatch from our premises.
Q
U
A
L
IT
Y A
SSUR
ED
F
IR
M
Our products also conform to the E.E.C. Machinery
Safety Directive and carry the C.E. mark.
CALIFORNIA USA
PROPOSITION 65 WARNING
Diesel engine exhaust and some of its
constituents are known to the State of
California to cause cancer, birth
defects, and other reproductive harm.
WARNING
Pumps and engines may be fitted with
seals or 'O' rings manufactured from
VITON or similar material.
When temperatures reach 400°C
(720°F) a corrosive acid is produced,
which cannot be removed from the skin.
If signs of material decomposition are
evident, or if in doubt,
always wear
disposable heavy-duty gloves .