6
Channels 1 and 4 for sub-woofer and bass frequencies
Channels 2 and 5 for mid-bass and medium frequencies
Channels 3 and 6 for mid-high and high frequencies
4. SIGNAL INPUTS
XLR cable connection used
A and B
5 Operation
The DT2006S receives a configuration for the Selenium's previous usages. This
configuration merges performance and the system's excellent intelligibility. Therefore, for the
user to control each track of the SLI-Ribbon265 system, then the signal's volume (intensity)
needs to be controlled at the sound table.
The configurations preset by Selenium can be changed, however, to meet the tastes of the
user or to adapt it to a specific type of application to which the system may be submitted.
Selenium recommends that before changing any of the DT2006S preset configurations that the
user contact our technical support team to clarify the implications of these changes to the
system's performance.
CAUTION, the DT2006S is configured to work at maximum power. This means that if you
turn on your table's sound system or mixer and your amplifiers are also at their maximum, the
sound will begin playing at maximum volume.
TIP: before turning on the system, set the sound table or mixer's volume at its minimum
and go turning up the volume carefully to the desired level or limit of your amplifiers.
The access to the DT2006S configuration commands is blocked by password. The only
commands accepted are the MUTE buttons.
If you need to make a change, contact Selenium to provide you with this password.
Any change to the configuration parameters should be done with extreme caution because
they can affect both the quality of the sound system as well as its durability, nullifying the
warranty against defects.
The buttons on the front panel of the DT2006S are used to change the parameters defined
by Selenium.
The sequence to do so is shown in the next chapter.
