9.MP3 / MPEG4 / JPEG OPERATION METHOD
11
12
10.HDMI OUTPUT MANUAL
System connection:
HDMI TV
Use type A <->Type A HDMI cable to connect the DVD player to the TV.
Turn ON both the TV and DVD player .Make sure the TV Video IN sourcoe is configured to
HDMI mode.
DVI monitor
Use type A<->Type B DVI cable to connect the player to the DVI monitor. DVI cable is not
driving audio.There fore,Audio is to be connected separately from the player to the Monitor
speakers or audio sound system User may select either the digital or the analog audio outputs
of the DVD player.
Turn ON the monitor and DVD player.Make sure the monitor Video IN source is configured to
DVI mode.
HD analog
Use 3X RCA cables to connect the HD analog components video outputs to the monitor.
Connect the player
s audio outputs to the Monitor speakers or audio sound system.
Turn ON the monitor and DVD player.Make sure the monitor Video IN source is configured
appropriately.
System configuration:
The following parameters should be configured as described below:
1.System must be in the right video mode (PAL or NTSC)
2.Vaddis must be in progressive mode
3.HD resoluti on can be changed
4.HD-JPEG resolution must be set up appropriately
HD resolutions
The DVD player reads imformation(EDID)from the TV to extract data such as type of TV
(HDMI/DVI)and resol ution,and configures the DVD resolutio on accordingly. However the
following remote control buttons can be sued to enable evaluation of other resolutions.:
B button-switches among resolutions. Each time the user presses the button,the resolution
changes according to the following cyclic mode:
In NTSC mode-480p,720p,1080i,1024*768p,1360*768p
In PAL mode-576p,720p,1080i,1024*768p,1360*768p
OSD indication with the new resolution is displayed temporarily,upon a change.
Notes:Can
s support HD jpeg.
HD jpeg
Images in JPEG format can be show nvia the HDX treme outputs in native high resolution.The
output esolution should be set via the Vaddis Video Set-Up menu.The avail able values are:
1360*768p/1024*768p/1080i/720p/SD(Standard resol ution).
In this mode:
ANGLE-used to rotate the mage by 90 degrees,180 degrees,270 degrees.(also support PAL)
Notes:
If the EDID data read by the DVD player from the TV, through the HDMI port,is not providing
imformation regarding the resol ution, the player drives the default mode to be 480p for NTSC
or 576p for PAL.
Notice that it takes few seconds for the TV to switch to the new resolution.Yet,it might be that
some resol utions are not supported by the TV,In this case,the user should press again the B
button,until the DVD switches to a resolution that is supported by the TV.
The default audio stream via the HDMI port is un-compressed PCM data.If the HDMI receiver
device (i.e.HDMI TV or HDMI AV receiver)can accept compressed data,the user may change
the output audio format to RAW through the Set Up menu.For more information on how to set
PAL/NTSC and RAW/PCM, please refer to the paragraph Set Up menu,o vide and audio setting.
Be advised that the rest of parameters within video and audio setting are not relevant for the HD
output.
