INSTALLATION GUIDE | ROMAN SHADES
UPDATED APRIL 2022
10
DELETING LOWER LIMITS AND INTERMEDIATE POSITIONS
NOTE:
Lower limits and intermediate positions can be deleted and reassigned. Upper limits can only be
removed by performing a factory reset.
1. To delete a specific shade position, use the UP or DOWN buttons to move the shade to the position
you want to remove.
2. Press and hold the PROGRAM button on the back of the remote for about 7 seconds. The shade will
jog once before the 7 seconds and once after. You have now deleted the limit/position from your shade.
7
sec
PROGRAM
BUTTON
PERFORMING A FACTORY RESET
1. Press the PROGRAM button on the MOTOR HEAD four (4) times in a row.
2. Press it again for a fifth time, holding the button down until the shade jogs twice.
3. Your shade’s memory and all presets have now been erased. To use the shade again, pair a
remote to it and then set new upper/lower limits.
USING THE REMOTE TO CONTROL YOUR SHADE
1. Press the UP or DOWN button once to move the shade to the next higher or lower position.
2. Press the UP or DOWN button two times (once per second) and the shade will move to the upper or lower limit position without stopping at
any intermediate positions you may have set.
MOTOR HEAD
PROGRAM
BUTTON
REPLACING THE REMOTE BATTERY
NOTE:
The battery used to power your remote is a coin-shaped
3V cell battery (CR2032). Additional batteries are not included.
1. To remove the back cover of the remote, use a small
screwdriver to remove the battery screw. Gently slide the back
cover up to disengage it, then lift it away from the remote.
2. Remove the old battery from the circuit board by sliding it
diagonally out of the bracket holding it down. Place a new 3V
cell battery in the bracket with the “+” positive side showing.
3. Replace the back cover of the remote, and secure the
battery screw.
RECHARGING THE SHADE BATTERY
NOTE:
If the shade begins to move at a slower pace,
the battery charge may be getting low. Plug the shade
into a power outlet and charge the battery for 6 hours.
1. Locate the charger cable behind the fabric on the
left side of the headrail. Connect this cable to the
provided battery charger.
2. Locate the charger port next to the programming button on the left side
of the headrail. Connect the USB-C cable to the provided battery charger.
Lithium Cell
CR2032
3V
Lithium Cell
CR2032
3V
MOTOR HEAD
CHARGER ADAPTER & CABLE
