7
Troubleshooting
Problem: The bottomrail is not level or the blind hangs crooked
Solution: Check that the headrail and installation brackets are level and
aligned. Shim the installation brackets if necessary.
NOTE: All skew adjustment features are located under the headrail.
To level the blind, raise the low side of the bottom rail by turning the screw
adjustment feature on the headrail clockwise with a coin or screwdriver while
lifting the weight from the bottom rail.
NOTE: Turn the scew sdjustment that is onthe same side as the low side of the
bottomrail.
If the blind height is too long, turn all the skew adjustment features clockwise to
raise the entire bottom rail to the desired height while lifting the weight from the
bottom rail. There is an adjustment range of approximately 1-1/4”.
Problem: The blind makes a ratcheting noise while the center button is
pushed in and the bottomrail is being raised.
Solution: Push harder on the center buttom. The button must be fully
depressed to raise or lower the blind.
Problem: When raising the blind, slats are not stacking evenly and falling over
the bottom rail.
Solution: The blind was raised too quickly. Gently raise the bottom rail to give
the lift cords time to retract. The slats will then stack evenly on the bottom rail.
