INSTRUCTIONS MANUAL
CODE 80014 REV E
01/2022
Pag.: 20
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: http://www.grupo-selecta.com
8 Operation
7.3 Platform installation
To fix the different platforms, do as follows:
- Loosen the four allen screws up.
- Place the platform.
- Tighten the four screws strongly keeping in mind that the platform has
to be griped by the four washers.
8.1 Starting up
- Connect the equipment to the power supply.
- Place and fix the material to be shaked on the platform.
- Turn on the main switch (1).
The display shows «-A-» for some seconds.
Keep in mind that if the equipment was stapped by the switch before
ending the work (unless having the set time not finished or by pressing the
start/stop key), the platform will start working at the last speed and time set.
- Normally, when the equipment is switched on, the display shows «000».
- To start, press the start/stop key (8). The work stops on pressing the
star/stop key (8) or when the set time finishes.
8.1.1 SETTING THE SPEED
After doing what is explained on section 8.1:
- Select the led (3) lighted up with the key (6).
- Press the key (5) and, keeping it pressed, select with
the keys (6) and (7) the set speed which will be showed
on the display (2).
8.1.2 SETTING THE WORKING TIME
After doing what is explained on section 8.1:
- Select the led (7) lighted up with the key (4).
- Press the key (5) and, keeping it pressed, select with
the keys (6) and (7) the set time which will be showed
on the display (2).
1
2
3
4
5
6
7
8
