MANUAL DE INSTRUCCIONES
CODIGO 80014 REV E
01/2022
Pag.: 19
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: http://www.grupo-selecta.com
6.4 Control panel
1. Main switch.
2. Speed and time display.
3. Speed selection indicator led.
4. Time selection indicator led.
5. Change set key.
6. Increasing value key.
7. Decreasing value key.
8. Start/Stop key.
6.5 Rear part
9. Fuse carrier.
10. Power supply cord.
6.5 Lower part
11. Voltage selector.
7 Installation
7.1 Placement
Place the piece of equipment near a socket, keeping in mind its amperage,
over a leveled surface enough resistant to support the weight indicated on
the table on section 3 (technical features) and the oscillations produced by
the working of the equipment. Do not use wheeled tables. Leave at least 30
cm around the equipment.
9
10
THERE ARE RISK OF BLOWS PRODUCED BY THE PLATFORM MOVEMENT
AND FINGER TRAPPINGS UNDER IT.
1
2
3
4
5
6
7
8
DO NOT INSTALL THIS EQUIPMENT IN EXPLOSIVE ATMOSPHERES OR IN
PLACES WITH SOLVENTS OR OTHER PRODUCTS WHICH MAY PRODUCE
EXPLOSIVE OR FLAMMABLE GAS.
7.2 Power supply connection
Make sure that the voltage given by the socket is the indicated on the cha
-
racteristics label attached on the rear part.
Do not use the equipment unless it is correctly earthed.
If you replace the plug, keep in mind the following:
Blue wire:
Neutral
Brown wire:
Phase
Yellow/green wire:
Ground
11
