INSTRUCTION MANUAL
CODE 80366 REV 0
NOV2018
(It can be modified without notice) Pag.: 14
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
e-mail: [email protected] - http://www.jpselecta.es
TROUBLESHOOTING
Problem
Possible cause
Solution
The equipment does not work
Plug’s bad connection
Unplug it and reconnect it to
the power supply
Abnormal compressor operation
or buzz
Supply voltage is outside the
nominal range
Disconnect the power source
immediately and reconnect it
when the voltage is normal. It
is necessary to have a voltage
stabilizer in case of poor power.
The compressor has been run
-
ning for too long and there is no
frost on the evaporator’s surface.
The cooling system is damaged
(leaking or blocked)
Send the unit to the technical
service for repair.
There is frost or ice on the cam
-
era’s internal walls and it has a
too low internal temperature. The
compressor always runs, it never
stops.
The thermostat does not work
Take it to the technical service
to repair.
The internal temperature is too
high and the compressor runs, it
never stops.
Bad heat dissipation and venti
-
lation of the housing, the room
temperature is too high.
Improve ventilation and lower
ambient temperature.
Door frequently open and for a
long time.
Decrease time and number of
times of door openings.
Too much noise
Unit is not level
Adjust the adjustable feet
Pipes touch the compressor.
Carefully separate the pipes
that touch each other.
The light is not on
The light has melted
Replace it
Warning:
- Keep the ventilation openings unobstructed, inside the appli
-
ance or in the built-in structure.
- Do not use mechanical devices or other means to accelerate
the defrosting process.
- Do not use electrical appliances inside the storage compart
-
ments of the equipment.
- It is forbidden to disassemble the unit by non-professional per
-
sonnel, it can be dangerous.
