INSTRUCTION MANUAL
CODE 80366 REV 0
NOV2018
(It can be modified without notice) Pag.: 12
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
e-mail: [email protected] - http://www.jpselecta.es
CAUTION!!! IMPORTANT FOR YOUR SAFETY
Be sure that the voltage supply is the same as the one indicated
on the characteristic plate of the equipment.
Do not use the equipment if it is NOT earthed.
If you have to change the plug bear in mind the following:
Blue cable: Neutral.
Brown cable: Phase.
Yellow/green cable: Earth.
PREPARATION
Remove the box and the packaging foam (including the bottom
foam) before using the equipment. Clean the unit before use.
Adjust the feet so that the unit stabilizes according to the ground
conditions to reduce noise.
After moving the unit, let it stand for about 30 minutes before
turning it on.
Running: close the door and turn on the power, turn on the light
switch at the back. The temperature should be adequate for normal
use after half an hour. Once the power is turned on, the unit must
remain empty for one hour.
CONFIGURATION & TEMPERATURE SETTINGS
Adjust the storage temperature through the temperature controller
located at the back of the unit. Adjust the temperature according
to the ambient temperature and the product to be stored.
The equipment has an adjustable control for the temperature,
which ranges from 1 to 5. Set the storage temperature by turning
the temperature knob clockwise. 5 shows the lowest storage
temperature. The knob can rotate freely but cannot be turned
clockwise from 5 to 1. The unit is factory set to 3.
Check if the knob is in the proper position before using the equi
-
pment. Frequent setting is not appropriate when using the equi
-
pment. Normally, in summer, the ambient temperature is high, so
we will turn the knob counterclockwise to 5; while in winter the
ambient temperature is low, therefore we will turn the control to
the right until 1.
0 position means stop the equipment.
