24
9.
Remove the last washer (17) and circlip (18).
10.
Remove the two springs, pawl and holder-
assemblies (19)
Clean the drive-shaft, holders, pawls and
springs from grease and dirt. If worn,
replace all pawls, holders, springs and
washers. A list of spare parts and kits can
be found in chapter 6 Spare parts.
Grease shall only be applied to the
gears, for lubrication of the pawls,
use pawl-oil.
11.
Reassemble all parts and the winch in
reverse order.
Recommended tightening torques
for screws are as follows:
M6=7 Nm
M8=12 Nm
17
18
19