• Pause function.
By pressing any of the arrow keys while program is executed, the opera-
tion stops temporarily and -the pen returns to the pen—up position.
To release the pause mode, press any of the arrow keys again. While the
plotter remains in the pause mode, the MANUAL RESET is available.
POWER lamp
• This turns red when the power is turned ON.
ALARM lamp
• This flashes red when an error occurs in the plotter. It indicates
detection of an I/O error not set in the error mask or an error
concerning the command.
• The lamp flickers during digitizing after receiving the "DP"command
and until
is pressed.
PAPER
HOLD
• Pushing this key turns on the PAPER HOLD lamp and puts electrosta-
tic -paper hold into operation. -Push-ing this again turns off the PAPER
HOLD lamp and releases electrostatic paper hold.
P.HOLD lamp
• While this lamp is on, electrostatic paper hold works. Pushing the
key turns on this lamp and pushing the key again turns
it off.
Pen selection
While the plotter is not in operation, a pen can be selected by manual
operation.
Press the
key while depressing the ENTER key.
When ALARM indicator starts blinking, release both keys.
Then press the control panel key corresponding to the number of the
pen to be used. For example, pressing
key selects pen l.
(see
Figure in page 12).
If the selected pen is not used within approx. 6 seconds, it is automati-
cally returned to its pen stall to prevent it from drying.
14
