ENTER
ENTER
KEY
• When the "DP "command is received, the ALARM lamp flickers. When
the pen is moved to a desired point and the NT E Key is pressed,
the ALARM lamp stops flickering and the coordinate value of that point
and the pen state are stored in the output buffer of the X —Y plotter.
This data is sent to the computer when the " OD"command is received.
• When the [ET] or [PE] key is pressed together with the
key,the current pen position is defined as a new scaling point PI or P 2.
P2 moves with Pl.
• When the [i] key is pressed together with the
key,the
coordinate system is rotated 90 0
When the
key is pressed together with the
key,all functions are reset to the initial state.
PI , P2Key
• When the
or
key is pressed, the pen rises and moves to the
scaling point PI or P2 set then.
• When the
key is pressed together with the
or
key,
the current pen position is set as a new scaling point PI or P2
• These four keys are used to move the pen
within the plotting limit. The
pen moves in the direction of the
arrow on the pressed key.
• When two adjacent keys are simultaneously
pressed, the pen moves in
the resultant direction (45 0 ) of the
two arrows of these keys.
• When the key is pressed, the pen moves
first at a low speed for 1.5
seconds and then, it moves at a
high speed (4 times faster than the low
speed).
13
