Maxima MPG Cod. EM00136006
rev. 1.1
18
Displaying and Operation
When operating in
CONSTANT
mode the display shows the flow rate set.
This can be displayed in three ways (
P, F, ml/min
) as explained in
Paragraph 3.1.1.
The
C
icon is lit. When displayed as a percentage the
%
icon is also lit. The
STOP
icon must be off while the
pump is running.
The pump is activated and stopped manually using the
START/STOP
button (the
Stop
icon is off or on
respectively).
To adjust the flow rate hold the
Mode
pushbutton and the
▲
or
▼
keys down together to increase or decrease
the flow rate value respectively.
3.2.2
n:1 proportional mode (Division Mode)
In this mode the pump doses one stroke every n impulses received, where n is a number that can be set by the
operator.
To select
n:1 DIVISION
mode, push the
Prog
key and hold it down. appears on the screen for a few seconds,
and then the main programming menu will open (
STOP
icon flashing). Push the
▲
and
▼
keys until Fn1
appears on the screen, with the
n:1
icon flashing.
Setting parameters from the n:1 menu.
From the main programming menu, when the
Prog
key is pressed the
n:1
icon stays lit and a specific menu
opens, as per the diagram shown below.
To exit programming and save the parameters set at any time, hold the
Prog
key down for three seconds.
Fig. 24:
n:1 division mode menu
Fn 1
Prog
n
Prog
Prog
1..9999
Prog
Memory
on/off
Flow
on/off
Press
the key
Press the
key
Press
the key
Press
the key
Press
the
k
Press
the keys
Press
the keys
