2
2 . NOTE: The orientation of gasket and parts are very important.
See above.
The hinge will ONLY allow the windshield to fold down flat in
one direction. You may find it helpful to place a piece of tape marking the
front side to avoid confusion in the following steps.
3 .
Attach the weather strip by pressing the channel in the gasket
onto the windshield with the bulb facing the
BACK
of the
windshield. The gasket will seal between the windshield and the
vehicle. Start the gasket at the middle of the bottom windshield
.
Front
Start the gasket at the bottom
1 .
Peel the plastic film back from all edges and holes of
the windshield before beginning. Remove after windshield
is fully installed.
Front
4 .
Assemble a windshield lever in the upper corner of the windshield
using the two holes closest to the edge as shown. The levers will be on
the
INSIDE
of the windshield. Tighten the nut so that the levers require
a slight amount of force to turn them. Repeat for the other side.
5 .
Assemble the female portion of the windshield holder in the
upper corner hole next to the lever as shown on the
FRONT
of
the windshield. Repeat for the one in the center and other side.
6 .
Assemble the male portion of the windshield holder in the
lower corner hole as shown on the
FRONT
of the windshield.
Repeat for the one in the center and other side.
