The Select and Tondo bath models suit both built-in and island installation.
1
Built-in installation
— see diagram below — the side of the bath is built into the wall.
The 50x25mm support battens run the full length of the bath in the wall.
2
Island installation
— see diagram below — there is a ledge between the wall and the side of the bath.
The minimum setout from the wall is 75mm. Refer to the local authority for local setout requirements.
3
Ensure that the area under the bath is
ventilated
in accordance with local requirements.
Island installation
19
45
10
compressed cement
fibre sheet backing
tiling
fill
50x25 batten
sealant
stud wall
suitable moisture barrier
run-off tube
tiles
bricks
(shape to fit
alongside bath)
standard 40mm
waste outlet
sealant
unfinished
floor
grade sub-floor
1:60 minimum (or
local requirement)
wall
page 2 of 2
compressed cement
fibre sheet backing
tiling
sealant
fill
water stop
suitable moisture barrier
standard 40mm
waste outlet
unfinished
floor
run-off tube
tiles
sealant
grade sub-floor
1:60 minimum (or
local requirement)
wall
Built-in installation
s e i m a . c o m . a u
Please note
−
All measurements are in millimetres.
−
Dimensions are nominal and subject to normal ceramic manufacturing variations of ±5mm.
−
Fixing: Use acetic cured silicone sealant. Do not use epoxy type adhesives.
−
Specifications may vary without notice as part of our continuous improvement practices.
−
Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.
