-
22
-
HINT
The printer enters the HEX Dump mode by pressing the POWER switch.
This mode can be checked to see the printer's transmission status. See
the Technical Reference for details.
If you do not press any switch within 30 seconds after a message is
printed, the printer turns off.
When the POWER and ERROR lamps start to blink, release your finger
from the POWER and ERROR switches within 5 seconds. If it is ongoing,
the printer exits function setting mode. In such a case, turn the printer off
and try the procedure from (1) again.
(4) If the message shown at the following is printed, press the FEED switch.
[SETTING MODE]
Yes: Feed SW / No: Power SW
HINT
If the POWER switch pressed, the printer exits the function setting mode
and turns the power off.
If you do not press any switch within 30 seconds after a message is
printed, the printer turns off.
The printer is now in the function setting mode. You can set functions by pressing
switches.
Changing Settings
In the function setting mode, initialize or modify the function settings. To set the settings
to defaults, perform operation (1). To change settings, perform operation (2).
(1) Initializing SWDIP switch settings
1. When the message shown at the following is printed in the function setting mode,
press the FEED switch.
Load Default Setting?
Yes: Feed SW / No: Power SW
2. When the message shown at the following is printed, the printer turns off. The
settings are set to defaults. Initialization is completed.
Default Setting Saved.
Setting Mode Finished.
