At trouble
Possible causes
Solutions
Reference
Misalignment
of the time
and hand
positions
The watch displays an
incorrect time hour unit,
even though it displays the
precise time of minutes
and seconds.
The time zone selection is incorrect. Check the selected time zone and set it
to the area where the watch is used.
P.32
Misalignment
of the date
The reception results are
successful and the precise
time is displayed, but the
date is not correctly
displayed.
The date is out of the preliminary
position.
This happens when the date is out of
the preliminary position as a result of
influence of various external sources or
after the built-in IC is reset.
Set the date to the preliminary position
“1” (the 1st).
P.87
Misalignme
nt of the
stopwatch
hands
After resetting the
stopwatch, the stopwatch
hands do not stop at the 0-
second position.
The stopwatch hands are out of the
preliminary position.
This happens when the stopwatch
hands are out of the preliminary
position as a result of external influence
or system reset.
Adjust the preliminary position of the
stopwatch hands to “0.”
P.91
Time zone Time zone cannot be set. The stopwatch hands are moving.
Reset the stopwatch before setting the
time zone.
P.40
EN
100
8
TROUBLESHOOTING
At trouble
Possible causes
Solutions
Reference
Operation The crown or button
cannot be operated.
The stored electric power is running
short.
Keep charging until the small seconds
hand is moving every second.
P.48
Hands and date are moving right after
a setting is carried out by the crown or
button operation.
Wait without doing anything.
After the date stops, the crown and
button can be operated.
-
Operation You get lost in the middle
of the operation.
-----------
Return to the status before the start of
the operation, and try the operation
again.
If the crown is pulled out, push it in.
If the crown is not pulled out, then pull it
out and push it in again.
This will return to one-second interval
movement for a maximum of 9 minutes.
After this, try the operation again.
-
Others Blur on the dial glass
persists.
A small amount of water has got inside
the watch due to deterioration of the
gasket, etc.
Contact the retailer from whom the
watch was purchased.
-
* For the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
EN
101
8
TROUBLESHOOTING
In case of an abnormal movement
In the case that the watch moves abnormally or that the watch does not move at one-second intervals even
after fully charging the battery, then it can be returned to normal operation using the following operation.
■ Reset the system
0 1 2
Pull out the
crown to the
second click
0-second
position
1
Pull out the crown to the second click.
The small seconds hand moves to the 0-second
position and stops.
* The date and stopwatch hands also stop.
* When the crown is a screw lock type, unlock it.
→ P.15
EN
102
8
TROUBLESHOOTING
Press
Button C for
3 seconds
Press
Button D for
3 seconds
2
Press and hold Button C and Button D
simultaneously for three seconds, and
then release them.
In five seconds after releasing the buttons, the small
seconds hand makes a full rotation and stops at the
0-second position.
Then the hour and minute hands will start to move
and stop pointing to 12 o’clock 0 minutes.
* The 24-hour hand moves accordingly with the hour
and minute hands, and stops at the 0-hour position.
* The stopwatch second hand moves, and then stops
at an arbitrary position.
* The button cannot be operated until all the hands stop.
EN
103
8
TROUBLESHOOTING
