Seiki SC-5100AU6A, Installation Manual

Page: 4 / 20

4
Read this manual thoroughly before you start installing the Split system air con.
Store this manual, the completed warranty card, your receipt and the product packaging.
The safety precautions instructions reduces the risk of fire, electric shock and injury when
correctly complied to.
Please follow all instructions and take notice of all warnings.
GENERAL SAFETY
These installation instructions for the Air conditioner are for use by an appropriately
qualified, licensed installer. The appliance mst be installed in accordance with all
applicable regulations. Do not try to install the Air conditioner on your own, doing so will
expose you to danger and void the warranty.
IMPORTANT INFORMATION
• Before installing this Aircon, make sure your outlet voltage corresponds to the voltage
stated on the power supply rating label.
• The ratings of the fuse installed in the indoor unit is 3.15A/250V,
and outdoor unit is 20A/250V
• DO NOT INSTALL THE UNIT
- In environments where the air could contain gas, oil or sulphur.
- Near sources of heat.
- At a distance of less than 50cm from flammable substances and pressurised containers.
• If the appliance is used in areas without sufficient ventilation, precautions must be taken to
prevent any leaks of refrigerant gas from remaining in the environment and creating a fire.
• Make sure that the base of the outdoor unit is firmly fixed.
• Check the air cannot enter the refrigerant system and check for refrigerant leaks
when moving the air con unit.
• Ensure that the mains voltage corresponds to that stamped on the rating plate.
• You must protect the indoor unit with a fuse of suitable capacity for the maximum
input current or with another overload protection device.
• Carry out a test cycle after installing the air con and record the operating data. Make
sure that air cannot enter the refrigerant system and check for any leaks when moving
the air con.