2
-EB dynamic driver earphones included
-Mono mix
UEM-8T
-2 mic/line XLR 1/4 inch combo inputs
- Input level adjustment
UEM-8DR Receiver
-Gain switch adjusting line input sensitivity
-1/4 inch line-level input jack for the connection with monitor mix, click tracks effects
-Cable management groove protects cables connected with bodypack
3. CONTROL ELEMENTS
3.1 UEM-8T
THE FRONT PANEL
1. Power switch
It switches on/off the main power of UEM-8T.
2. Headphone output
This is a 6.3mm phone jack for headphone monitoring.
3. Headphone volume control
It controls volume level for headphone.
4. LCD display
2. Features
UEM monitor system
-16 channels /frequencies selectable (Each channel corresponds to a frequency)
In this menu mode, you can choose the right value via these two keys.
5. UP/DOWN key
frequency.
The LCD shows RF signal, group value, channel value, audio level and the selected
5
4.3.5 Battery Replacing & Installation
The double colour LED turns red, this indicates the battery low. Please replace
them with new batteries.
Please pay attention to that battery positive/negative should exactly correspond
to that of the receiver before the battery replacement. There is explosion
danger if the battery is incorrectly replaced. Replace the battery only with the
same or equivalent type.
.
Note:
1 After operation the unit should be switched off as well. Otherwise the batteries
will soon be exhausted. If LED of receiver lights up green, this indicates that the
receiver works well. If LED lights up red, this indicates that the wireless receiver
do not work. Please check if the channel is the right one which corresponds to
that of the transmitter. .
CAUTION
4.2.3 RF output power
Press SET key three times and RF power could be then set. Use UP and DOWN key to
adjust the audio output power. The output power has two choices, 0 stands for 10mV, 1
stands for 100mV. When the RF power has been set, please press MEM key to save it.
4.3 UEM-8DR RECEIVER
4.3.1 Turn on the power switch
4.3.2 Select the channel which corresponds to that of the transmitter.
4.3.3 Put the ear phone plug into stereo socket for listening.
mode of selecting channel. Use UP or DOWN key to select the channel you want. When
one channel is selected, the corresponding frequency is presented. If one channel is
selected, press MEM key to save it. If one channel is selected from the transmitter, select
the corresponding channel from receiver.
Notes
: For frequencies of channels in detail, please refer to the Annex.
4.3.4 Adjust the volume control Adjust the volume by turning the volume control.
1 Battery use DC9V.
2 Do not drop the ear phone body on the floor.
3 Protect the unit from humidity and heat.
4 If the units don't work, bring them to technical engineer for disposal.
5 Volume level should not be too loud in case ears are hurt.
1
2
3
5
6
7
4
