Page 8
Figure 9
Attach Bracket (F) to the back of the
top panel (8) with screws (I).
Tighten screws (I) using Phillips
screwdriver.
Mark two desired locations on the wall
and drill two 3/16" holes.
Insert anchors (G) into the two holes on
wall as shown. Use a hammer to insert
the plastic anchors until they are flush
with the wall.
Then attach the brackets (F) onto the
wall using screws (H).
Tighten screws (H) using Phillips
screwdriver.
Figure 10
Move this item close to the wall bracket
(F) and tie in all brackets (F) together
with plastic strap (E) as shown in
diagram.
Anti-tipping hardware must be used for
this product to avoid tipping and injury.
Top supports up to 85 lb.
F I
F
I
