Segway i2 SE, Service Manual

Page: 74 / 92

Segway Personal Transporter SE Service Manual 13–2
Motor
Removal
Tools Required: Small flathead screwdriver
T-25 6-lobe wrench
1. Make sure the PT is powered off, unplugged, and the
batteries have been removed.
2. Establish a Serviceable Powerbase ( page 8–2 ).
3. Remove the Radio Board ( page 9–3 ).
4. Remove the Console ( page 9–4 ).
5. Remove the Chassis Cover ( page 10–2 ).
6. Remove the Gearbox on the same side of the PT as
the Motor you want to remove ( page 7–2 ).
7. Disconnect the two CU motor harnesses from the
motor. Using a small flathead screwdriver, gently lift
the tab on the connector, then carefully pull on the
connector to unseat it. See
Figure 13–1 .
8. Using a T-25 6-lobe wrench, remove the two
fasteners attaching the Motor to the Chassis. See
Figure 13–2 .
9. Pull the Motor straight out of the Chassis.
Motor
Figure 13–1: CU Motor Harnesses