Segway i2 SE, Service Manual

Page: 59 / 92

Segway Personal Transporter SE Service Manual 9–7
Console
AC Input Filter
Removal
Tools Required: 4 mm hex wrench
T-20 6-lobe wrench
T-10 6-lobe wrench
1. Make sure the PT is powered off, unplugged, and the
batteries have been removed.
2. Establish a Serviceable Powerbase ( page 8–2 ).
3. Remove the Radio Board ( page 9–3 ).
4. Detach the Console from the Powerbase
( page 9–4 ).
5. Disconnect the Power Supply Harness from the
AC Input Filter. Press down on the tab while gently
pulling the connector out of the socket. See
Figure 9–10 .
6. Using a 4 mm hex wrench, detach the ground lug
from the Console Base. See Figure 9–10 .
7. Using a T-20 6-lobe wrench, remove the two
fasteners holding the AC Input Socket in place.
Discard the fasteners. See
Figure 9–8 .
8. Using a T-10 6-lobe wrench, remove the five
fasteners holding the AC Input Filter in place.
Discard the fasteners.
9. Remove the AC Input Filter.
10. Using ESD best practices, place the AC Input Filter in
an ESD bag for return shipment to Segway.
11. Remove the insulator.
Figure 9–8: AC Input Filter
20567-00001 (self-tapping)
20973-00001 (non-tapping)
1.6 N-m (14 in-lbf)
Insulator
23591-00001
3.0 N-m (27 in-lbf)
23559-00001
1.0 N-m (9 in-lbf)
AC Input
Socket
AC Input Filter
Console Base