Power Button:
Press the button to turn on; press and hold the button for 3 seconds to turn off. When the KickScooter is on, press the button
to turn on/off the headlight and the rear light, and press twice to switch between the speed modes.
Speedometer:
It displays the current speed of the scooter, as well as error codes.
Walk Mode:
Max. speed is 5 km/h (3.1 mph).
The headlight and rear light are always on and can't be turned off.
* How to enable it in the Segway-Ninebot app: Tap the sidebar menu >
Settings
>
Walk Mode.
Speed Mode:
There are three modes. The top speed is as follows:
Error Notification:
It indicates that the scooter has detected an error.
Temperature Warning:
It indicates that the battery temperature has reached 55°C (131°F) or is below 0°C (32°F).
* At this point, the vehicle cannot accelerate and may not be charged. Do not use until the temperature has reverted to the normal range.
Bluetooth:
It indicates that the scooter has been successfully connected to the mobile device.
Battery Level:
The total battery level equals 5 bars.
* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.
Model
Mode
G65E
15 km/h
20 km/h
25 km/h
ECO
(Energy-saving mode)
D
(Standard mode)
S
(Sport mode)
Dashboard & Power Button
Walk Mode
Speedometer
Speed Mode
Bluetooth
Error Notification
Battery Level
Power Button
Temperature Warning
Headlight
Assembly
4
1
2
4
Slide the handlebar onto the stem with the headlight
facing forward.
* Make sure the wires inside the handle and the stem
are connected.
Headlight
3
Install the six screws in order (two on each side)
with the included hex wrench.
(3.0 ± 0.5 N·m)
3
2
1
4
5
6
Power on the KickScooter.
2
1
Unfold the stem. Close the quick-release lever, and lock
with the safety hook. Then unfold the kickstand.
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
