41
3.13.3.2.
Replacing The Media Board Battery Pack
Prohibitions and Cautions to Handle the Battery Pack
•
Be careful when handling the battery pack.
•
We bear no responsibility for problems caused by handling clearly contrary to the content of this
manual.
•
Do not disassemble the battery pack and the batteries.
•
If you should fail to observe this instruction, the internal wires and/or protective
devices may be damaged; as a result the safety system may not function when
discharging and recharging, eventually causing an overheating, fire and
explosion. If you should disassemble the batteries, the generated gases may
harm your throat and the negative plate may overheat and make a fire.
•
Do not make an external short circuit of the battery pack and the batteries.
If you should fail to observe this instruction, the batteries may overheat, make a
fire, and explode.
•
Do not fire the battery pack and the batteries.
If you should fail to observe this instruction, the batteries may make a fire and
explode.
•
Do not leave the battery pack and the batteries nearby the heat source (fire or
heater) or under the intense direct sunlight and flaming sun.
If you should fail to observe this instruction, the batteries may reduce the service
life and in the worst case may overheat, make a fire, and explode.
•
Do not leave the battery pack and the batteries in water or seawater. Also do not
apply water or seawater onto the battery pack and the batteries. If you should fail
to observe this instruction, the internal wires and/or protective devices may be
damaged; as a result the safety system may not function when discharging and
recharging, eventually causing an overheating, fire and explosion. Also water
may be electrolyzed into oxygen and hydrogen, and eventually the battery's
sealed section may be corroded and the internal liquid may leak.
•
Do not solder on the battery pack's terminals.
If you should fail to observe this instruction, the armor may be heated and
melted or the internal wires may be damaged, eventually causing an
overheating, fire and explosion. Also, when the battery's temperature reaches to
100•Ž or more, the battery may leak its internal liquid due to destruction of its
plastic parts (gasket, separator, etc.), or may overheat, make a fire, or explode
due to internal short-circuit.
•
Do not insert or connect the battery in a reversal polarity.
If you should fail to observe this instruction, the battery may be externally short-
circuited and eventually overheat, make a fire, or explode, depending on the
device you connect with.
Summary of Contents for Outrun 2
