OWNER’S MANUAL
|
Make sure that the device is switched off
before cleaning.
Wipe the surface of the heater by using a clean
damp cloth.
Do not use chemical liquids when cleaning
the heater.
Do not submerge the heater in water.
Make sure that the heater has cooled down
completely before storing. Storing in its original
packaging is highly recommended.
Cleaning the filters
WARNING!
Ensure that the heater is switched
off at the supply mains before removing filter
panel.
Remove the filter and clean using a vacuum
cleaner or tap the panel lightly to remove loose
dust and dirt and then rinse under running
water (no hotter than 40°C).
Dry thoroughly before replacing.
Note! To maximize the efficiency of the heater,
clean the filters regularly.
Note! Never operate the heater without the
filters and air inlet grille installed.
CLEANING AND STORING
4
Waste electrical products must not be disposed of with household waste.
This product should be taken to your local recycling centre for safe treatment.
Timer
1. Press the SHIFT button once to enter into
timer setting mode. The temperature / timer
display will flash on the display panel.
2. Press the UP and DOWN buttons to set the
time before the heater automatically turns
off. Pressing UP and DOWN will increase
and decrease the time by 1 hr increments.
Timer range is 1-12hrs.
3. Press the SHIFT button or wait 4 seconds
to confirm the timer setting. The display
will now cycle between the current room
temperature and the timer countdown.
4. Reset the timer by re-entering the timer
setting mode and using UP and DOWN to
set a desired time.
5. To cancel the timer setting, set the timer to
zero (00) hours or turn the heater off.
OPERATION CONT.
