4
5.2
Connection Port & LED Indicator of SC-VRD0001A
Please connect the SC-VRD0001A, receiver, to the correspondent devices as
follows
①
Video Input: connect to the transmitter via the coaxial cable
②
DIP SW: set up the communication configuration. It is set in OFF in
default.
※
DIP SW (BAUDRATE / PARITY)
Mode / SW No.
1
2
3
9600 bps / None (default)
OFF
OFF
OFF
4800 bps / None
ON
OFF
OFF
2400 bps / None
OFF
ON
OFF
1200 bps / None
ON
ON
OFF
Reserved
OFF
OFF
ON
9600 bps / Even
ON
OFF
ON
9600 bps / Odd
OFF
ON
ON
Auto detect / None
ON
ON
ON
※
Resistance of the Termination
Mode / SW No.
4
Disconnected (Default)
OFF
Connected 120 OHM
ON
Notes:
Please turn the power OFF after changing the switch (SW) and then turn it ON.
The auto detection is available with 1200, 2400, 4800, 9600 only.
The size of packet should be lower than 21 bite.
③
2P Terminal Block: connect the power adapter (24VAC / 12VDC)
④
4P Terminal Block: 2P for alarm input, 2P for alarm output
⑤
LED Indicator:
- Green: it flickers when it transmits the data
- Yellow: it turns on when the power is on and it flickers when it receives
the data.
⑥
Video Output: connect to the DVR or the monitor.
⑦
RS-485: connect to the PTZ controller such as camera controller
①
②
③
④
⑤
⑥
⑦
