Once the two are fully rotated into position the Raspberry Pi and the Flick board should sit nicely in
the bottom part of the case.
Before moving to the next step please take a moment to understand which knock outs need to be
removed from which of the two panels.
If you intend to close the case you need to remove the knock outs from panel 1 otherwise if you want
to keep the case open remove the knock outs from panel 2.
Only remove the ones labelled Headphones, HDMI and Power.
If you are not planning on using the suction cups and wish to close up the case then follow the step
below otherwise skip to the Section – Flick HAT Case Assembly With Suction Cups.
